Rose CrystalLink USB 2.0 Fiber Instruction Manual download pdf (Page 9)

TROUBLESHOOTING

Installation and Operations Manual

Figure 1 outlines the basic installation of the CrystalLink USB 2.0 Fiber

extender. The installation steps below are a guide to properly install the

units and cabling.

Figure 1. Installation

Before you install the CrystalView USB 2.0 Fiber extender, it is

recommended that you pre-plan you system layout, consisting of the

placement of the computer, the routing of the fiber cabling, and the

location of the USB device(s).

1. Connect the transmitters USB Type A cable connector to an unused

USB port on the computer.

2. Connect the provided power adapter to the power jack on the receiver

unit. Use only the furnished power adapter. Other power adapters may

cause permanent damage to the receiver unit and void the warranty.

3. Connect the fiber optical cable to the transmitter’s and receiver’s

Duplex LC connectors.

4. Connect the provided power adapter to a 100/240 V AC 50 – 60 Hz

power source.

5. Install any required software to operate the USB device(s).

6. Connect the USB peripheral to the USB Type A connector on the

receiver unit.

Verifying the installation

1. Check that the USB device is detected and installed properly in the

operating system.

2. Verify that the CrystalView USB 2.0 extender has installed correctly by

opening the Device manager and expand the USB controller section

(click on the + sign). You should see the unit listed as a Generic USB

Hub.

3. Verify the Power, Host, and Link LEDs are on and the Activity LED is

blinking. If any LED is off, check the cabling.

Transmitter Receiver

Fiber Cable

USB 1.1 or 2.0

peripherals

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Rose CrystalLink USB 2.0 Fiber Instruction Manual Page 9